My brilliant life blog 0017

Test subtitle

Nobody has ever died of a filthy keyboard, and the PC doesn't get really faster using a cleansed notice solar panel both. But who wishes to show the brand new 24-inch TFT should there be a rotten key-board with coffee stains and leftovers facing it?

Cleaning is very easy because you do not have to pay attention to special coatings. There are problems with cheap keyboards alone because here the key names are only printed: the color dissolves with a strong detergent. In such a case, you'd better buy a new model for ten euros. In the more expensive versions, the keys are labeled with a laser, so they cannot come off.

First, hold the keyboard upside down Article source and tap on the underside, the coarsest dirt may fall out. The use of compressed air spray is very helpful here. This also frees the gaps from accumulated skin flakes, bread crumbs, and broken pencil leads. Then use a soapy water and cotton swab to clean every space on the keyboard and then wipe the keys with a paper towel.

It is even easier with a keyboard cleaning set. The supplied plastic cleaner dissolves fat even better than the soapy water. The sponge helps with the application, with which the keys and spaces can be cleaned in one wash.

As an alternative to the Data Becker set, the Swiss manufacturer Cyber ​​Clean offers a special cleaning paste that has a germicidal effect and at the same time makes the buttons shine. The highlight: the sponge behaves like plasticine and adapts to any unevenness. So you can easily get into the gaps without cotton swabs.

In the event that the keyboard still does not meet your hygiene standards even after you have cleaned it, there is a simple and effective method: the dishwasher. The only catch is the keyboard electronics because you have to remove them beforehand. Usually, however, this is limited to a small circuit board.

First, use a blunt knife to pry all the keys out of the keyboard. So that everything comes back to its old place afterward, it is best to take a photo of the button layout. With some keyboards, the keys are all attached to a mat - where you do not have to pry out the individual keys but can put the entire mat in the machine. Then use a screwdriver to loosen the screws from the underside of the keyboard and open the housing.

Now remove the electronics - in most cases, you will have to loosen additional screws. The rest goes into the dishwasher. Temperatures up to 40 degrees are no problem for the keyboards. Therefore, if possible, use the 35-degree rinsing process and a normal cleaning stick. You can wipe the rubber mat with a damp cloth.

Then allow the cleansed parts free of moisture then and thoroughly reassemble the keyboard in turn back buy. Just click the individual buttons firmly inside the appropriate placement.